elevator car

英 [ˈelɪveɪtə(r) kɑː(r)]

美 [ˈelɪveɪtər kɑːr]

网络  电梯轿厢; 轿厢; 电梯车厢

英英释义

noun

• where passengers ride up and down
  1. the car was on the top floor
  Synonym:car

双语例句

• ⑵ Through MATLAB software on traction elevators were 12 degrees of freedom vibration model and the horizontal direction perpendicular to 8 degrees of freedom vibration model simulation, respectively, high-speed elevator car by the maximum peak to peak vertical vibration and horizontal vibration of the dynamic model curve.
  ⑵利用MATLAB软件分别对曳引电梯的12自由度垂直振动模型和水平方向8自由度振动模型进行仿真，分别得到高速电梯轿厢垂直振动的最大峰峰值与水平振动的动力学模型曲线。
• The laser beam pass through the collimator and illuminate one dimensional photocell array vertically which is set on the top surface of the elevator car.
  本文中半导体激光器放置在电梯井道顶端，激光束经过准直系统，垂直向下照射安装在轿厢的上表面的一维光电池探测器阵列。
• Vibration acceleration response of the elevator car is used as feedback signal and thus the engineering implementation of the active control will be simplified.
  采用电梯矫厢的振动加速度作为反馈信号，将使主动控制在工程上易于实现。
• Then, according to the main line of building and interior design style development, the author sum up the design style flow of passenger elevator car, carrying on a design research in esthetics.
  进而，依照建筑和室内设计风格发展的主线，对乘客电梯轿厢设计的风格流派总结归纳，进行美学层面上的设计研究。
• The light turns on as soon as the elevator car is activated, such as when the elevator doors open.
  电梯启动像电梯开门这种情况下，灯会立即开启。
• It analyzes a hydraulic elevator car frame used in the museum, sets up its multi-loops structure and variable working conditions load.
  某博物馆液压电梯轿厢架具有多重框架的结构特点和变工况的载荷特征，传统公式计算法难于进行应力和变形分析。
• Officials say the child's leg was lodged between the elevator car and shaft, with the child's body hanging below the elevator car.
  官方称小孩的腿夹在机井和电梯厢中间，身体在电梯厢以下。
• In the present study, a two-dimensional model of the elevator car and counter weight system was set up;
  此外，本文还建立了全三维的电梯轿厢-对重模型，定量分析了气动力的大小。
• Design of an elevator car controller based on CAN Bus
  基于CAN总线的电梯轿厢控制器设计
• There exist problems of longer design cycle and lower efficiency with common mechanical product design method. In response to it, this paper presents and illustrates a CAD method based on modular and parameterized design, with the aid of elevator car design.
  针对传统机械设计方法设计周期长、产品形式单一的问题，本文以电梯轿厢结构设计系统为例提出了基于模块化和参数化设计的机械产品CAD方法。